05-ring-s JPG
(551.56 KB, 1632x1224)

06-base-s JPG
(609.46 KB, 1632x1224)

07-knight-s JPG
(598.21 KB, 1632x1224)

08-ohmygodimgonnablee... JPG
(632.04 KB, 1632x1224)

#5 - A ring where it can be sawed when it's ready. There will be the base.
#6 - Shaping the base, kinda round. It will be much more slim and slender, but I leave about this size for now so I won't break the thing down accidentally.
#7 - A couple of minutes after I decided this will be a horsie. A knight that is. I want one on the end of the try stick too. This will be the trial run.
#8 - At this point as I smeared some blood on the piece I realized I nicked the tip of my thumb. I had the choice to stop or continue with holding the stick awkwardly as I try not to bloody it more but this would hinder the process, and become a source of mistakes and maybe further wounds. No thanks.

Dunno when I will finish this, won't take long, one more session. However I found at least one designing flaws I made. But maybe it will be all right, just have to make the figurine smaller.