>>> bb/183773@153873
White and fluffy like cotton is a hum, everything is not white and not fluffy - does not eat hum without opening it. White and fluffy will slowly grab the whole jar, just watch the growth and check once a day or two, do not slow down growth. If it slows down for a long time (for example, more than 3-5 days), then most likely mitz faced the growth of a competing powerful mold or there is a bacterial infection, such a jar is also thrown out. While growing, order a coconut briquette and prepare a suitable container for shubox / monotube, at the same time, just in case, make a few more reserve cans with another grain to not waste time. When the jar is overgrown, you will pour coco at night with boiling water, in the morning with your hands in gloves and with a mask you will get a grain (you immediately understand that everything is going right, there will be a strong mushroom smell from grain, noble such) you will mix the cooled coco with grain in your monotube, level without much trambing (don’t forget the container before this all the alcohol to wipe), on top you will sprinkle a layer of coco about 1 cm, the cover layer is called. Well, that's all, again, wait until everything is over, don't open the container, look through the wall cho there. Half of the holes for ventilation at this stage it is better to seal with tape so that the mitz does not have a draft inside, he does not need air at the fouling stage, a couple of three holes will be enough. When the whole cocoa grows and even on top of the cover layer will be white by 70-80%, then it is time to open all the ventilation holes (don’t forget that they should have cotton discs for air filtration or Omnipore, a good thing, I advise you to find it in the pharmacy, take the widest) and start every day to open the lid several times for ventilation. Mitz will receive a signal of increased oxygen levels and begin to form such small white bubalehas on the cover layer. At this stage, the finish line, further from these bubalehs will climb already thugs. Remove from the most beautiful prints on foil - carefully cut the leg under the hat itself, put the hat with plates down on the foil rubbed with alcohol, cover with a plastic cup and close in the closet in the dark for a day, then gently drop the hat with a toothpick, let the print lie down for another day to dry and that's all, you are ready for new research.